DZ60 v3 PCB (USB-C)

DZ60 v3 PCB (USB-C)

  • $ 44.99

  • USB C
  • PCB is black
  • 16 bright RGB LED's for underglow
  • All components and RGB LEDs presoldered, you only have to solder switches and backlighting LEDs
  • Completely and easily reprogrammable using this editor (instructions below).
  • Supports various layouts shown in the picture above
  • Gold plating for easier soldering and aesthetics (subjective)
  • Runs QMK
  • Programmable RGB underglow lighting

How to use

Flash custom firmware (Windows):
1. Download and install FLIP here
2. Connect the keyboard and press the reset button
3. Open device manager, find the ATMEGA32u4 chip and click "update driver"
4. Choose location manually: folder named "USB" inside the installation directory of FLIP
5. Once the driver is installed, open FLIP
6. Device -> Select: choose ATMEGA32u4
7. Settings -> Communication -> USB, FLIP should show the signature at this point (58 1E 95 87)
8. File -> Load HEX file: select the hex file you created using
9. click "Run"
10. After programming is done, disconnect the device from USB and connect again.

Flash custom firmware (Linux):
1. Download and install/compile/unpack dfu-programmer from
2. Issue the following commands in the command prompt after connecting the device and pressing the programming button (S1). You may need root permissions or udev rules to do that.
sudo dfu-programmer atmega32u4 erase
sudo dfu-programmer atmega32u4 flash [name of hex file]
sudo dfu-programmer atmega32u4 start
The keyboard should start working. If it doesn't, reconnect the cable.

Related Items

Back to the top